Recirculation Door Motor -V113-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

NOTE:

Check the function of the doors and linkage before installing.

Check if the levers and shafts are seated correctly in the mounts.

-- The fresh air door must be in the "closed" position, to install the Recirculation Door Motor -V113-.

Courtesy of AUDI OF AMERICA, LLC

The actuating shaft -2- must contact the stop -1- -arrow- as shown.

NOTE:

If the actuating shaft of the actuator is not set to the "fresh air mode" stop, turn the mount in the actuator.

-- The fresh air door must be in the "open" position so the fresh air comes into the vehicle.

-- Switch the ignition on.

-- Connect the affected actuator to the vehicle wiring harness and select the setting for the desired actuator position on the display control head (for example in the center position). Wait until the actuator reaches the desired position and switch the ignition off.

-- Mount the actuator on the air intake housing. While doing so, the actuating shaft must engage into the mount.

There must not be any play in the connection between the actuating shaft and the mount.

NOTE:

If the screws cannot be installed, the actuator does not sit completely on the housing.

-- Route the wiring harness so that it cannot come in contact with any moving parts (for example, the actuator lever).

-- Check the DTC memory and erase any displayed entries, then perform the "basic setting". Use the Vehicle Diagnostic Tester in the "Guided Fault Finding" function.

-- Check the heating and A/C system function.