Front Three-Point Seat Belt, Removing And Installing: Removing
Risk of injury due to involuntary deployment.
- Pay attention to the safety precautions when working with pyrotechnic components. Refer to SAFETY PRECAUTIONS WHEN WORKING WITH PYROTECHNIC COMPONENTS .
- Observe the disposal regulations for pyrotechnic components. Refer to AIRBAG, BELT TENSIONER AND BATTERY CUT-OUT UNITS, STORING, TRANSPORTING AND DISPOSING (PYROTECHNIC COMPONENTS) .
-- Switch the ignition on.
-- Move the front seat all the way forward and up.
-- Disconnect the battery ground cable when the ignition is turned on. Refer to BATTERY, DISCONNECTING AND CONNECTING .
-- Remove the front sill panel. Refer to SILL PANEL, REMOVING AND INSTALLING .
-- Remove the B-pillar upper trim panel. Refer to B-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- Remove the B-pillar lower trim panel. Refer to B-PILLAR TRIM PANEL, REMOVING AND INSTALLING .
-- Remove the front seat belt guide. Refer to FRONT SEAT BELT GUIDE, REMOVING AND INSTALLING .
-- Remove the bolt -1-.
-- Remove the seat belt relay -2- with the seat belt webbing.
Risk of injury due to involuntary deployment.
- Before handling pyrotechnic components (for example, disconnecting the connector), the person handling it must "discharge static electricity". For example, this can be done by briefly touching the door striker.
-- Disconnect the connectors -3- and -5- to do so remove the connectors.
-- Remove the bolt -7-.
-- Unclip the belt end fitting -1- from the bracket -6-.
-- Guide the belt end fitting tensioner -1- through the B-pillar upper trim panel.
-- Remove the bolt -2- and then remove the automatic belt retractor -4- from the mount.