LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2023 >> ID.4 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 85 (Passenger Protection, Airbags, Seat Belts) >> 69 Passenger Protection, Airbags, Seat Belts >> Seat Belt Fastening Detection >> Passenger Seat Occupant Detection Sensor -G128-, REMOVING AND INSTALLING >> Installing

Passenger Seat Occupant Detection Sensor -G128-, REMOVING AND INSTALLING: Installing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION:

The new passenger occupant detection sensor should be installed in the same location as the old sensor.

Install in the reverse order of removal while noting the following:

NOTE:

Make sure the connectors are pushed in all the way and that they engage audibly.

NOTE:

If the Airbag Indicator Lamp -K75- indicates a fault after installing, check the DTC memory, erase it and check it again using the Vehicle Diagnostic Tester.

scientia non olet · About LEMON Manuals