Seat Belt For Child Seat, Checking Child Seat Restraint Function, Market-Specific

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

To check the function, the entire belt system must be installed, including the side trim panel

Hold Function, Switching On

Pull out the seat belt all the way.

Proper Function

The belt must retract with a chattering sound.
If the retracting process is stopped, the belt cannot be pulled out anymore.

Switching Off

Belt retraction to about 100 mm remaining.
Hold function must switch off with a remainder of 100 mm, at the latest. The belt functions normally again.

If the seat belt for the child seat restraint function does not work, replace the seat belt