Rear Parking Aid Sensors -G203- / -G204- / -G205- / -G206-, Removing And Installing: Removing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

Exterior Sensors:

CAUTION:

The outer rear parking aid sensor can be remove and installed without removing the rear bumper.

-- If equipped, remove the rear underbody trim panels. Refer to COMPONENT LOCATION OVERVIEW - UNDERBODY TRIM PANELS .

-- Push both tabs in the direction of the -arrow A-. At the same time push through the sensor -1- from the outside to the inside.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -2-.

Interior Sensors:

-- Remove the rear bumper cover. Refer to BUMPER COVER, REMOVING AND INSTALLING .

-- Push both tabs in the direction of the -arrow A-. At the same time push through the sensor -1- from the outside to the inside.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -2-.