Left Seals Between Bevel Box And Transmission On Bevel Box, Replacing: Removing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the bevel box. Refer to BEVEL BOX, REMOVING, VEHICLES WITH 3.6L, 206 KW ENGINE .

Remove the >>outer<< seal

-- Pry out the seal using the Puller - Crankshaft/Power Steering Seal:T20143/2

Fig 1: Identifying Pulling Hook T20143/1 Or T20143/2 To Pry Out Sealing Ring On Bevel Box

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Removing the >>inner<< seal

NOTE:

To prevent the new seal from being damaged later:

-- Remove the circlip -1- from the stub shaft.

Fig 2: Identifying Circlip And Flange Shaft

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Carefully remove the stub shaft -2- using a plastic hammer in the direction of the -arrow-.

-- Remove the stub shaft seal on the transmission side.

Fig 3: Identifying Slide Hammer -VW 771- Complete Set

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.