TIGUAN (BJ2)
All part and service references provided in this document are subject to change and/or removal. Always check with the Parts Information for the latest information.
| Engine | Part | Part Number | Quantity |
|---|---|---|---|
| 2.0L DTEA | Oil Filter | 06L 115 562 B | 1 |
| VW 508 00 (SAE 0W-20) | N/A | 5.7 L | |
| Drain Plug w/Seal | 06L 103 801 | 1 | |
| Air Filter | 5Q0 129 620 B | 1 |
| Miscellaneous | Part | Part Number | Quantity |
|---|---|---|---|
| Miscellaneous | Dust and Pollen Filter | 5Q0 819 644 A | 1 |
| Front Wiper Blade (Left) | 5NN 955 425 | 1 | |
| Front Wiper Blade (Right) | 5NN 955 426 | 1 | |
| Rear Wiper Blade (370 mm) | 5NN 955 427 | 1 | |
| Rear Battery (Amp. Req. Vary)* | 000 915 105* | 1 | |
| Battery (Amp. Req. Vary)* | 5TA 915 105* | 1 |
For battery DIN information, refer to Vehicle Data / PR Number
| 2021 | Engine Size | Engine Code | Torque Specification |
|---|---|---|---|
| Oil drain plug Torque | 2.0L | DTEA | 30 Nm |
| Wheel hub bolt Torque | 2.0L | DTEA | 140 Nm |
Resetting the service interval display
| Vehicles with analog instrument cluster | |
|---|---|
| 1. | Switch the ignition off. |
| 2. | Press and hold the 0.0 button in the instrument cluster. |
| 3. | Switch the ignition back on. |
| 4. | Release the 0.0 button when one of the following messages appears in the instrument cluster display: >>Reset oil change service? or Reset inspection service?<< |
| 5. | Press the 0.0 button in the instrument cluster to confirm. |
Vehicles with a digital instrument cluster
The service interval display can only be reset through the >>Service<< menu.
| Vehicles with Volkswagen Digital Cockpit Pro | |
|---|---|
| 1. | Select the >>Service<< menu and follow the instructions on the instrument cluster display. |
| 2. | Select the >>Range<< information profile. |
| 3. | Press and hold the OK button on the multi-function steering wheel for approximately four seconds. |
| 4. | Navigate in the menu using the buttons on the multi-function steering wheel. |
| Vehicles with Volkswagen Digital Cockpit Basic | |
|---|---|
| 1. | Select the >>Service<< menu and follow the instructions on the instrument cluster display. |
| 2. | Select the >>Travel time/distance driven << secondary display. |
| 3. | Press and hold the Menu with Back arrow or Menu with Forward arrow button on the multi-function steering wheel in the same direction for approximately six seconds. |
| 4. | Use the ↑ and ↓ arrow buttons to navigate the menu. |
Do >>not<< reset the service reminder between service intervals; or incorrect information will be displayed.
If the oil change service was manually reset, the service interval display then also switches to a fixed service interval, even on vehicles with >>flexible oil change service<<.
The service message automatically disappears after a few seconds when the engine is running or by pressing the OK/RESET button on the windshield wiper lever or the OK button on the multifunction steering wheel.
If the 12 V vehicle battery in a vehicle with the flexible service interval has been disconnected for an extended period, the time for the next oil change service cannot be calculated. Therefore, the service interval displays may show incorrect calculations. If this is the case, follow the maximum permissible maintenance intervals.