Left Parking Brake Motor -V282- /Right Parking Brake Motor -V283-, REMOVING AND INSTALLING: Removing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Ignition must be switched off for at least 30 seconds before disconnecting the connector.

-- Remove the connector -2- from the parking brake motor -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove both hex socket bolt -arrows- from the parking brake motor.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the parking brake motor from the brake caliper, while doing so turn the parking brake motor back and forth.

-- Remove the seal.

NOTE:

Make sure that the ring groove of the seal and the contact surface of the parking brake motor do not become damaged.

-- Clean the parking brake motor ring groove and contact surface.