Trailing Arm With Mounting Bracket, Removing And Installing: Removing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

-- Loosen the wheel bolts.

-- Raise the vehicle.

-- Remove the wheel.

-- Remove the spring. Refer to SPRING, REMOVING AND INSTALLING .

-- If equipped, remove the underbody trim panel on the trailing arm mounting bracket. Refer to COMPONENT LOCATION OVERVIEW - UNDERBODY TRIM PANELS .

-- Remove the line -1- from the trailing arm -2-. To do this push out the inner pins from the bracket -arrows-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Secure both sides of the vehicle on the hoist lifting arms using the :T10038 .

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Tensioning Strap:T10038

WARNING:

The vehicle could slide off the hoist if it is not secured.

-- Position the :VAS6931 or :VAG1383A -1- under the tie rod and push slightly upward.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the bolts -2 and 3- one after the other.

-- Remove the : VAS6931 or :VAG1383A -1- from under the tie rod.

-- Remove the line -2- from the mounting bracket -1-.

Fig 1: Tighten The Bolts -arrows-

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Mark the installation position of the mounting bracket -1- on the body.

-- Remove the bolts -arrows-.

-- Remove the trailing arm with mounting bracket.