Overview - Stabilizer Bar
WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.
- Subframe
- Stabilizer Bar
- With rubber bushings
- Removing and installing. Refer to STABILIZER BAR, REMOVING AND INSTALLING .
- Bolt
- 20 Nm +90°
- Replace after removing.
- Install evenly
- Coupling Rod
- Removing and installing. Refer to COUPLING ROD, REMOVING AND INSTALLING .
- Bolt
- 50 Nm +180°
- Replace after removing.
- Lower Transverse Link
- Bolt
- Replace after removing.
- Nut
- 20 Nm +180°
- Replace after removing.