Adaptive Cruise Control (Acc), Calibrating, Dynamic Calibration

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

Before calibrating the adaptive cruise control (ACC), check the sensor and its mounts and attachments for damage, external influences and secure fit. Repair any damaged components.

Prior to calibrating the adaptive cruise control (ACC), check the event memory and correct any malfunctions.

The ACC control module "adjustment angle measured value" shows whether the sensor is misaligned.

Proper ACC operation requires correct calibration.

-- The Control Module for Adaptive Cruise Control -J428- must be calibrated under the following conditions:

Distance Regulation Control Module -J428- was replaced
The lock carrier service position was performed
The lock carrier was removed and installed.
The lock carrier was replaced
The adjustment angle is outside of the tolerance. Perform a tolerance check using the Vehicle Diagnostic Tester.
The rear axle toe was adjusted.
Changes were made to the suspension that affect the height.

-- Connect the Vehicle Diagnostic Tester.

-- Select "Individual test plan" on the Vehicle Diagnostic Tester.

-- Press the following buttons one after another on the screen:

Diagnostic-capable systems
0013 - Distance control
0013 - Distance control, functions
0013 - Calibrating

Follow the instructions on the screen to perform the calibration.