Rear Emblem, Replacing: Installing
WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.
-- Clean the adhesive surface -4- with adhesive remover before bonding.
- The adhesive surface -4- must not have any dust, grease or adhesive residue on it.
-- Remove the protective film on adhesive tape from the emblem -1-.
-- Place the emblem -1- with the centering pins -2- in the indentations -3- on the rear lid.
-- Push the brand emblem on using force.