Assembly Instructions
WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Adhesive Strip Remover:VAS 6349
- If removing and installing the name badge, only use the Adhesive Remover:D 002 000 10 to remove the adhesive residue.
- If necessary, remove any adhesive residue left by the tape using Adhesive Strip Remover:VAS 6349 .
- Make sure the adhesive surfaces are free of dust and grease.
- Apply the name badge immediately after cleaning.
- Only remove the protective film right before assembly.
- The temperature must be approximately 21 °C (69.8 °F).