LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2023 >> ID.4 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Exterior Equipment) >> 66 Exterior Equipment >> Moldings, Trims, Extensions And Trim Panels >> Wheel Arch Trims, Removing And Installing >> Wheel Cover, Removing And Installing, Rear >> Installing

Wheel Cover, Removing And Installing, Rear: Installing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Follow the assembly instructions. Refer to ASSEMBLY INSTRUCTIONS .

-- Replace the damaged clips -2- and grommets -4-.

-- Place the wheel cover -1- with the clips -2- in the grommets -4-.

-- Remove the protective film from the adhesive tape -6- and push the wheel cover with the clips -2- in the grommets -4- in direction of -arrow a-.

-- Push the hook -5- in the bumper cover in direction of -b arrows-.

-- Push in the wheel cover -1- on the adhesive surface -6- in the side panel using force.

-- Tighten the bolts -3-.

scientia non olet · About LEMON Manuals