LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2023 >> ID.4 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 58 (Exterior Equipment) >> 66 Exterior Equipment >> Moldings, Trims, Extensions And Trim Panels >> Wheel Arch Trims, Removing And Installing >> Wheel Cover, Removing And Installing, Front >> Installing

Wheel Cover, Removing And Installing, Front: Installing

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Pay attention to the assembly instructions for the bonding. Refer to ASSEMBLY INSTRUCTIONS .

-- Replace the damaged clips -4- and grommets -3-.

-- Remove the protective film from the adhesive tape -2- at the bottom of the fender.

-- Place the wheel cover -1- with the centering drift -5- and the clips -4- in the grommets -3-.

-- Remove the protective film from the adhesive tape -2- and push the wheel cover with the clips -4- in the grommets -3- in direction of -arrow a-.

-- Push the wheel cover -1- in the bumper cover in direction of -b arrows-.

-- Push in the wheel cover -1- on the adhesive surface -2- in the fender using force.

-- Tighten the bolt -6-.

scientia non olet · About LEMON Manuals