Assembly Instructions
WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.
- It is not possible to remove the trim molding on the rear lid without damaging it.
- There are different versions. Refer to the appropriate Electronic Parts Information for the allocation.
- If installing the trim molding for the first time on a new vehicle or a newly painted surface, follow the procedure. Refer to the appropriate Paint Repair Information; →Paint Repairs; →Paint Finish; →Decorative Molding and Films.
- If removing the trim molding, only use the adhesive remover to remove the adhesive residue in the installation area.
- If necessary, remove any adhesive tape residue with Cleaning Solution:D 009 401 04 or Naphtha 291001.
- Make sure the adhesive surfaces are free of dust and grease.
- Apply the trim molding immediately after cleaning.
- Only remove the protective film right before assembly.
- The temperature must be approximately 21 °C (69.8 °F).