Assembly Instructions

WARNING: This page is about a different car, the 2023 Volkswagen Atlas. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Adhesive Strip Remover:VAS 6349

Fig 1: Adhesive Remover VAS 6349
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Wiring Harness Repair Set - Hot Air Blower:VAS 1978/14A

Fig 2: Hot Air Blower VAG1416
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

The covers of the chrome trim moldings cannot be removed from the covers without damaging. There are different versions, refer to the appropriate Electronic Parts Information for the allocation.
If installing the cover for the first time on a new vehicle or a newly painted surface, follow the procedure. Refer to the appropriate Paint Repair Information; →Paint Repairs; →Paint Finish; →Decorative Molding and Films.
If removing the cover, only use the adhesive remover to remove the adhesive residue in the installation area.
If necessary, remove any adhesive residue left by the tape using Adhesive Strip Remover:VAS 6349 .
Make sure the adhesive surfaces are free of dust and grease.
Apply the cover immediately after cleaning.
When reusing the cover, replace the two-sided adhesive tape.
Only remove the protective film right before assembly.
The temperature must be approximately 21 °C (69.8 °F).