Mounting Bracket, Removing And Installing, RHD: Removing

WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

-- Refer to DRIVER SIDE INSTRUMENT PANEL COVER, REMOVING AND INSTALLING .

-- Refer to DRIVER SIDE FOOTWELL VENT, REMOVING AND INSTALLING .

-- Refer to CRASH BOLSTER, REMOVING AND INSTALLING .

-- Disconnect the connector from the Accelerator Pedal Module -GX2-.

-- Refer to Brake Pedal, Removing and Installing, RHD Vehicle .

-- Remove the nuts -1- to -5-.

Fig 1: Mounting Bracket - tightening specification and sequence

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the mounting bracket.

If the mounting bracket is replaced:

-- Disconnect the Accelerator Pedal Module -GX2- from the mounting bracket. Refer to ACCELERATOR PEDAL MODULE GX2, REMOVING AND INSTALLING .

Continuation for all vehicles