Right And Left Rear Abs Wheel Speed Sensor G44/G46, Removing And Installing: Removing
WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
The following information describes the removing and installing on the left side of the vehicle as an example.
The Right Rear ABS Wheel Speed Sensor -G44- and Left Rear ABS Wheel Speed Sensor -G46- will be called rear speed sensor in the information that follows.
-- Raise the vehicle.
-- Disconnect the connector -2- from the rear speed sensor -3-.
-- Remove the bolt -1- and pull the rear speed sensor -3- out of the wheel bearing housing.