Stabilizer Bar, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the rear underbody trim panel. Refer to REAR UNDERBODY TRIM PANEL, REMOVING AND INSTALLING .

-- Remove the impact guard. Refer to IMPACT GUARD, REMOVING AND INSTALLING .

-- Install the Engine/Gearbox Jack - Gearbox Support: T10337 -A- to the Engine and Gearbox Jack: VAS 6931 -B-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Position the Engine/Gearbox Jack - Gearbox Support: T10337 -A- at the stabilizer bar -1-.

Conditions

The mount of the Engine/Gearbox Jack - Gearbox Support: T10337 -A- only contacts the stabilizer bar -1-.

-- Slightly push the stabilizer bar -1- upward.

-- Remove the nut -6- from the coupling rod -1-. At the same time, counterhold on the internal multi-point bolt on the coupling rod -1-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the coupling rod -1- from the stabilizer bar -5-.

-- Remove the bolts -3- and -4- for the stabilizer bar -2- on the subframe -1-. At the same time hold the stabilizer bar.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the stabilizer bar -2- from the subframe.