Coupling Rod, Removing And Installing: Removing
WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
-- Refer to Wheel, Removing .
-- Install the Engine/Gearbox Jack - Gearbox Support: T10337 -A- to the Engine and Gearbox Jack: VAS 6931 -B-.
-- Position the Engine/Gearbox Jack - Gearbox Support: T10337 -A- at the stabilizer bar -1-.
Conditions
- The mount of the Engine/Gearbox Jack - Gearbox Support: T10337 -A- only contacts the stabilizer bar -1-.
-- Slightly push the stabilizer bar -1- upward.
-- Remove the nut -4- from the bolt -2- at the rear upper control arm -3-.
-- Remove the bolt -2-.
-- Remove the nut -6- from the coupling rod -1-. At the same time, counterhold on the internal multi-point bolt on the coupling rod -1-.
-- Remove the coupling rod -1- from the stabilizer bar -5-.