Rear Body Acceleration Sensor G343, Removing And Installing: Removing
WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
The Rear Body Acceleration Sensor -G343- will be called rear body acceleration sensor in the information that follows.
The following information describes the removing and installing on the left side of the vehicle as an example.
-- Remove the rear left sill panel. Refer to REAR SILL PANEL, REMOVING AND INSTALLING .
-- Disconnect the connector -3-.
-- Remove the bolt -4- and remove the rear body acceleration sensor -1-.