Tie Rod End, Removing And Installing: Installing

WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Install the tie rod end -3- up to the previously made marking on the tie rod -1- and secure with the nut -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Insert the tie rod end -3- into the wheel bearing housing.

-- Tighten the tie rod end -3- with the new nut.

-- Perform the axle alignment. Refer to Axle Alignment .