Suspension Strut, Removing And Installing: Installing
WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Adjust the distance between the Suspension Strut Pre-loading Device - Support Plate: VAS 751 005/3 and Suspension Strut Pre-loading Device - Support Plate: VAS 751 005/2 to the noted values using the spindles.
Conditions
- For the following procedure two technicians are necessary,
- The guides -3- must be seated correctly in the body.
-- Tighten the bolts -2-.
Vehicles with level control system sensor
-- Perform the necessary function with the Vehicle Diagnostic Tester. Refer to Diagnostic Entries .
Continuation for all vehicles