Ball Joint, Removing And Installing: Notes
WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
Special tools and workshop equipment required
- Puller - Ball Joint: 3287A
The Left Front Level Control System Sensor -G78- and the Right Front Level Control System Sensor -G289- will be called front level control system sensor in the information that follows.
The following information describes the removing and installing on the left side of the vehicle as an example.
Required special tools and equipment:
- Torx Bit T40, commercially available