LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2023 >> ID.4 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 50 (Front Suspension) >> 40 Front Suspension >> Lower Control Arm And Ball Joint >> Ball Joint, Removing And Installing >> Installing

Ball Joint, Removing And Installing: Installing

WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

CAUTION:

Leaks on the ball joint due to a damaged boot.

- Make sure the ball joint boot is not damaged or twisted.

-- Remove the nut and at the same time counterhold with a commercially available Torx Bit T40.

Vehicles with front level control system sensor 

-- Perform the necessary Function/Functions with the Vehicle Diagnostic Tester. Refer to Diagnostic Entries .

Continuation for all vehicles 

scientia non olet · About LEMON Manuals