Data Bus on Board Diagnostic Interface -J533-, REMOVING AND INSTALLING: Removing
WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
If the data bus on board diagnostic interface is replaced, perform the test plan for replacing the control modules:
-- Perform the "Control module, replacing" function with the Vehicle Diagnostic Tester. Refer to Diagnostic Entries .
Continuation
-- Remove the glove compartment lid. Refer to GLOVE COMPARTMENT LID, REMOVING AND INSTALLING .
-- Open the retainers -1-.
-- Remove the data bus on board diagnostic interface -3- until the connectors -2- are accessible.
-- Disconnect the connectors -2-.
-- Remove the data bus on board diagnostic interface -3-.