Striker, Adjusting
WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
-- Remove the lock carrier trim panel. Refer to LOCK CARRIER TRIM PANEL, REMOVING AND INSTALLING .
-- Loosen the nuts -2-.
-- Move the striker -1- into the upper position and push in -direction of the arrow A- or -direction of the arrow B-.
-- Tighten the nuts -2- by hand.
-- Close the rear lid.
Requirement
- The opening on the Rear Lid Lock Unit -VX25- must engage with its rotary latch centered to the striker.
-- Check the adjustment.
Tightening Specifications
- Refer to Overview - Rear Lid .