Power Rear Lid Opening Sensors G750/G760, Removing And Installing: Installing
WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Remove the adhesive residue and the adhesive surfaces. Refer to Installation Requirements for Components with Adhesive Tape .
-- Remove the protective film from the adhesive tape.
-- Position the power rear lid opening sensor -1- in the areas marked -2- and press it on.
-- Roll on the power rear lid opening sensor -1- using the Roller: T40400 in the area of the adhesive tape with a force of 65 N.
Requirement
Pay attention to the differing minimum curing time. Refer to Installation Requirements for Components with Adhesive Tape :
- The minimum curing time of 30 min must be met.