Bumper Carrier, Removing And Installing: Installing
WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
Requirement
- The help of a second person is necessary for the following procedure.
-- Slide the bumper carrier -1- in the -direction of the arrow- onto the Guide Rods :T10625 -3- and -4-.
-- Secure the left and right cotter pin -5-.
-- Install the bolts -2- securely but do not tighten them.
-- Remove the long Guide Rod :T10625 -3- from the left and right subframe.
-- Install the outer bolts -6- securely on the subframe, but do not tighten them.
-- Remove the short Guide Rod :T10625 -4- from the left and right longitudinal members.
-- Install the inner bolts -6- on the left and right longitudinal members, but do not tighten them.
Install in reverse order of removal. Note the following:
-- Tighten the bolts -2- and -6-.