Seat Occupant Detection Sensors G177/G178/G1010, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

Remove the rear seat occupant detection sensors G177/G178

The Driver Side Rear Seat Occupant Detection Sensor -G177- and Passenger Side Rear Seat Occupant Detection Sensor -G178- will be called the seat occupant detection sensors in the information that follows.

-- Remove the rear bench seat cover and cushion. Refer to Rear Bench Seat Cover and Cushion, Removing and Installing .

-- Disconnect the connector -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Guide the wire through the opening -arrow-.

-- Remove the rear seat occupant detection sensor -1- or -2-.

Rear center seat occupant detection sensor G1010, removing

-- Remove the rear bench seat cover and cushion. Refer to Rear Bench Seat Cover and Cushion, Removing and Installing .

-- Disconnect the connector -2-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Guide the wire through the opening.

-- Remove the Rear Center Seat Occupant Detection Sensor -G1010- -1-.