Airbag Unit With Driver Airbag Igniter N95, Removing And Installing: Installing

WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

CAUTION:

Pyrotechnical components can deploy unintentionally.

Risk of injury.

- Discharge the static electricity: quickly touch the door striker.

-- Install the connector and press it on until it audibly locks.

-- Secure the connector on the rear side of the airbag unit.

-- Make sure the wires are not pinched.

-- Position the airbag unit in the steering wheel and press on it until it audibly engages.

-- Connect the battery ground cable. Refer to BATTERY, DISCONNECTING AND CONNECTING .

CAUTION:

Pyrotechnical components can deploy unintentionally.

Risk of injury.

- Keep as far away as possible from the pyrotechnic component when switching the ignition on.

-- Switch the ignition on.

-- Check and clear the DTC memory using the Vehicle Diagnostic Tester.