Airbag Control Module J234, Removing And Installing, LHD: Installing

WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Attach the connector until it clicks into place.

-- Connect the battery ground cable. Refer to BATTERY, DISCONNECTING AND CONNECTING .

CAUTION:

Pyrotechnical components can deploy unintentionally.

Risk of injury.

- Keep as far away as possible from the pyrotechnic component when switching the ignition on.

-- Switch the ignition on.

-- Check and clear the DTC memory using the Vehicle Diagnostic Tester.

If the Airbag Control Module -J234- is replaced:

-- Perform the "Start-up completion" function using the Vehicle Diagnostic Tester. Refer to Diagnostic Entries .

Continuation