Seat Frame Wiring Harness, Removing And Installing: Installing

WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Route the wire in their original locations.

Vehicles with seat position sensor

-- Hook the seat position sensor -1- into the seat pan lower frame.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Position the 4 mm plate from the Gauge - Gap Adjustment: 3371 -4- in between the seat position sensor -1- and the seat pan lower frame.

-- Tighten the bolt -2-.

-- Remove the Gauge - Gap Adjustment: 3371 -4-.

Continuation for all vehicles