Roof Reinforcement, Attaching To Body: Installing
WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
Conditions
- Processing instructions of adhesive must be observed when installing roof reinforcements.
-- Apply beads -3- of one-part assembly adhesive (refer to the Electronic Parts Information (ETKA)) with a diameter of 6 mm to the roof reinforcements -1- and -2- according to the specifications that follow using the Cartridge Gun: V. A. G 1628 .
- Dimension -a- = 95 mm
- Dimension -b- = 105 mm
- Dimension -c- = 20 mm
- Dimension -d- = 21 mm
-- Position the front roof reinforcement -1- according to dimension -a- at the center of the roof and press on the entire surface.
- Dimension -a- : 56 ± 3 mm from the rear edge of the panel
-- Position the rear roof reinforcement -2- according to dimension -b- at the center of the roof and press on the entire surface.
- Dimension -b- : 24 ± 3 mm from the front edge of the panel
-- Install the headliner. Refer to Headliner, Removing and Installing .