Sun Visor, Removing And Installing: Removing

WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

The following information describes the removing and installing on the left side of the vehicle as an example.

-- Pivot the sun visor forward.

-- Remove the Driver and Front Passenger Vanity Mirror Lamps W20/W14. Refer to the appropriate service information .

-- Disengage the sun visor -2- from the sun visor center support -1- and fold it to the side.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Pry out the caps -3- using a small screwdriver.

-- Position the Release Pliers : T10558A in the center of the clips -3-.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Release the front clip -3- (when viewed in the direction of travel) in the sun visor mount -1- using the Release Pliers : T10558A .

-- Pull the sun visor -2- down gently so that the front clip -3- does not engage again.

-- Release the rear clip -3- (when viewed in the direction of travel) in the sun visor mount -1- using the Release Pliers : T10558A .

-- Pull the sun visor -2- downward.

CAUTION:

There is a risk of damaging the wires by pulling too hard.

- Carefully pull the wires out of the opening.

-- Disconnect the connector.

-- Remove the clamping plate.

-- Remove the sun visor.