Sun Visor, Removing And Installing: Installing

WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

Install in the reverse order of removal while noting the following:

-- Place a layer of foam tape around the connector.

-- Reach into the vanity mirror lamp opening with one finger.

-- Pull the headliner downward slightly.

-- Route the connector between the headliner and the roof crossmember.

-- Engage the front clip (when viewed in the direction of travel).

-- Engage the rear clip (when viewed in the direction of travel).

-- Check if both clamps are secured.