Roof Grab Handle, Removing And Installing: Removing
WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
The following information describes the removing and installing on the left side of the vehicle as an example.
-- Fold down the roof grab handle -1-.
-- Unclip the caps -2- using a commercially available plastic wedge.
-- Fold the roof grab handle down -1- and hold it.
-- Press the Release Tool :T10518A -2- in the -direction of the arrow- until the clip -3- releases.
-- Pull the Release Tool : T10518A -2- with roof grab handle -1- opposite the -direction of the arrow-.
-- Repeat the procedure for the other clip -3- while holding the roof grab handle -1- with tension so that the clip -3- does not engage again.
-- Remove the roof grab handle -1-.