Sill Panel Trim, Removing And Installing: Installing
WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Remove the adhesive residue and the adhesive surface. Refer to Installation Requirements for Components with Adhesive Tape .
-- Align the sill panel trim -1-.
- Dimension -a- = 175 mm
- Dimension -b- = 7 mm
-- Remove the sill panel trim protective film -1-.
-- Press on the sill panel trim -1- onto the outer side sill -2- starting from the front moving toward the rear, using a force of 20 N.
-- Roll on the sill panel trim -1- with Roller: T40400 in the area of the adhesive tape using 20 N.
Requirement
- First the outer area of the sill panel trim must be rolled on, then the inner area -1-.
- The minimum curing time must be complied to. Refer to Installation Requirements for Components with Adhesive Tape .