A-Pillar Cover, Removing And Installing: Installing
WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
Install in the reverse order of removal while noting the following:
-- Remove the adhesive residue and clean the adhesive surface -2-. Refer to Installation Requirements for Components with Adhesive Tape .
-- Align the A-pillar cover -1- in the -direction of arrow A- at the roof frame molding and the indentation in the A-pillar.
-- Remove the protective film from the A-pillar cover -1-.
-- Align the A-pillar cover -1- on the A-pillar -3- and press the cover on.
-- Press the A-pillar cover -1- on in the area of the adhesive tape with a force of 50 N.
Requirement
- The minimum curing time must be complied to. Refer to Installation Requirements for Components with Adhesive Tape .