Rolling Resistance Tires

WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

Tire label. Refer to EU TIRE LABEL .

Rolling Resistance Tires can unlike conventional tires (tread depth approximately 7.5 mm) have a significantly lower tread depth in new condition. Tread depth between 5 and 6 mm are possible.

A significant approval criteria is that the millage on the VW wear rate must fulfill a minimum delivery rate until the wear limit of 1.6 mm remaining tread depth is reached.

The minimum delivery rate on the wear rate on the rolling resistance tires and not rolling resistance tires are identical.

The environmental compatibility of these tires is higher due to low wear pro km than conventional tires. High fuel efficiency or high electric range are also the result of low roll resistance.

Tires approved by manufacturer are rolling resistant and conform to all safety and customer relevant properties.

NOTE:

The tire wear and the vehicle range per tank/change depends on the significant measurements of the driving profile.

The corresponding recommended tire brands should be taken from the Electronic Parts Information (ETKA).