Valve, Removing And Installing, Metal Valve: Installing

WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

NOTE:

Only apply the specified torque to tighten the nut for the metal valve.

Tightening more is not permitted because it damages the seal.

-- Tighten the nut -1- of the metal valve.

Fig 1: Identifying Metal Valve

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Counterhold -arrow- the metal valve using a retainer (for example 2 mm spiral bore) while doing so.

-- Install the Tire Pressure Monitoring Sensor --. Refer to TIRE PRESSURE MONITORING SENSOR, REMOVING AND INSTALLING, WITHOUT VALVE, VERSION 1, SERVICE VERSION .