Calibration Device: VAS 721 001, INSTALLING AND ALIGNING: Notes

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

After performing service work on the vehicle, it may be necessary to calibrate the peripheral camera system. In detail, this is the case after:

Replacing one or more cameras
Replacing the control module
Flashing the software of the control module
Writing the data set on the control module
Repair work on components in which a camera is installed or that influence the component location of the camera
Wheel Alignments
When adjusting the overlap range of the individual cameras
The standing height of one axle changes by more than 5 mm
The standing height of the entire vehicle changes by more than 10 mm