Three-Phrase Current Drive VX54, Calibrating

WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

Calibrating the Three-Phase Current Drive -VX54- is necessary if:

The DTC memory for the relevant OBD systems was deleted.
The Electric Drive Control Module -J841- software was updated.
The Electric Drive Control Module -J841- was replaced.
The Electric Drive Power and Control Electronics -JX1- was replaced.
The Three-Phrase Current Drive -VX54- was replaced.

The calibration is automatically performed during the first driving operation. Until the drive motor is successfully calibrated, the driving power is limited.

If the calibration is done manually:

-- Perform the "Electric Drive Motor, Calibrating" function using the Vehicle Diagnostic Tester. Refer to Diagnostic Entries .