Driveshaft, Removing And Installing, TIGUAN: Notes

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

Special tools and workshop equipment required

Counterhold - Kit - Multiple Use:T10172

Fig 1: Counterhold - Kit - Multiple Use T10172
Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Engine Support:T50015A

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.
Engine Support Device - Gearbox Bracket:T10346/1

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

A two-column workshop hoist should be used when working on the driveshaft.
Label the position of all the parts to each other before removing them. Install in the same position otherwise the imbalance will be excessive and the bearings could get damaged causing rumbling noises.
Do not bend the driveshaft, only store and move when fully extended.
Do not allow the driveshaft to >>hang down<< during removal. Always support it.
Always remove or install the driveshaft horizontally with respect to the drive flange.