All-Wheel Drive Clutch Pump -V181-, REMOVING AND INSTALLING, GENERATION IV: Installing

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

Install in reverse order of removal while noting the following:

If a new All-Wheel Drive Clutch Pump -V181- is being installed, a basic setting must be performed after installing.

-- Replace the O-rings -1- and -2-.

Fig 1: Identifying O-Rings

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Apply a thin coat of All-Wheel Drive Clutch Oil on the O-rings -1- and -2-.

-- Push the pump -arrow- all the way into the all-wheel drive clutch housing.

Fig 2: Haldex Clutch Pump V181

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Tighten the bolts -1-.

Tightening specification: 6 Nm

-- Clip the wiring harness to the top of the all-wheel drive clutch and attach the connector -arrow- to the control module.

Fig 3: Clipping Wiring Harness To Haldex Clutch Securely And Placing Connector On Control Module

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Add new All-Wheel Drive Clutch Oil. Refer to ALL-WHEEL DRIVE CLUTCH OIL, DRAINING AND FILLING .