Bumper Cover, Removing And Installing: Installing

Install in the reverse order of removal while noting the following:

Installation is only possible with a second technician.

-- If equipped, connect the connectors for the electrical components.

-- Guide the bumper cover -1- parallel to the vehicle -a arrows-.

-- Push the bumper cover -1- onto the center, left, and right guides under the tail lamp -2- until they engage with each other -arrow b-.

-- Push the bumper cover -1- onto the left and right guides -3- on the side panel until they engage with each other -arrow c-.

-- Pay attention to the gap dimensions.

-- Push the expanding rivets -6- firmly from below.