Evacuating And Charging Valve, Removing And Installing, Low And High Pressure Side: Removing
WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.
Immediately seal off any open lines and connections with clean plugs from the Engine Bung Set :VAS 6122 .
-- Refer to REFRIGERANT CIRCUIT, DISCHARGING .
-- Remove the cap -3-.
CAUTION:
Danger of frostbite due to refrigerant coming out under pressure.
Frostbite on the skin and other parts of the body is possible.
- Wear safety gloves.
- Wear protective eyewear.
- Evacuate or drain refrigerant and open the refrigerant circuit immediately.
- If more than 10 minutes have elapsed since evacuating or draining the refrigerant and the refrigerant circuit was not opened, evacuate or drain the refrigerant again. Pressure develops in the refrigerant circuit due to evaporation.
-- Remove the valve insert -2- together with the Socket :T10364/4A