Overview - Heater And A/C Unit Air Intake Housing

WARNING: This page is about a different car, the 2022 Volkswagen ID.4 and 2021 Volkswagen ID.4. However, it is still accessible from the selected car via links, so may be relevant.

Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

Fresh Air Intake Cover
Fresh Air Intake
- Refer to Fresh Air Intake, Removing and Installing .
Bolt
- Pay attention to the tightening sequence. Refer to Air Shroud, Removing and Installing .
- Quantity: 3
- 8 Nm
Air Shroud
- Refer to Air Shroud, Removing and Installing .
Nut
- Pay attention to the tightening sequence. Refer to Air Shroud, Removing and Installing .
- Quantity: 7
- 8 Nm
Bolt
- Quantity: 4
- 2 Nm
Cap
Bolt
- Quantity: 3
- 2 Nm
Fresh Air Blower Control Module -J126-
- Refer to Fresh Air Blower Control Module -J126-, Removing and Installing .
Heater and A/C Unit Air Intake Housing
- Refer to Heater and A/C Unit Air Intake Housing, Removing and Installing .
Nut
- Quantity: 5
- 4 Nm
Bolt
- Refer to OVERVIEW - ADJUSTMENT MOTORS, PR NUMBER KC0, KH4 / OVERVIEW - ADJUSTMENT MOTORS, PR NUMBER KH7 .
Actuator for Fresh and Air Recirculation Door -VX96-
- With Fresh Air/Recirculating Air/Back Pressure Door Motor -V425-
- With the Fresh Air/Recirculating Air/Back Pressure Door Motor Position Sensor -G644-
- Refer to ACTUATOR FOR FRESH AND AIR RECIRCULATION DOOR -VX96-, REMOVING AND INSTALLING .
Noise Insulation
Dust and Pollen Filter
- Refer to Dust and Pollen Filter, Removing and Installing .
Dust and Pollen Filter
- Depending on equipment/version
- Refer to Dust and Pollen Filter, Removing and Installing .
Cover
Bolt
- Depending on equipment/version
- 2 Nm
Noise Insulation
Seal
Seal