LEMON Manuals: Even more car manuals for everyone
Home >> Volkswagen >> 2023 >> ID.4 S >> Repair and Diagnosis >> External Pages >> Different car >> Section 168 (Turbocharger, Supercharger) >> 21 Turbocharger, Supercharger >> Charge Air System >> Air Duct Pipe, Removing And Installing, DNPA, DNNA, DNND And DRNA >> Front Air Duct Pipe, Removing And Installing >> Removing

Front Air Duct Pipe, Removing And Installing: Removing

WARNING: This page is about a different car, the 2023 Volkswagen Arteon. However, it is still accessible from the selected car via links, so may be relevant.

-- Remove the air duct on the lock carrier. Refer to the appropriate Service Information .

-- Remove the noise insulation. Refer to OVERVIEW - NOISE INSULATION .

-- Loosen the clamp -2- and remove the charge air hose.

Fig 1: Identifying Clamps
GWWA21-10489Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Remove the fan shroud. Refer to [For engine(s) DSFB] Fan Shroud, Removing and Installing .

-- Remove the coolant hose from the clip -3-.

Fig 2: Disconnect Charge Air Pressure Sensor Connector
GWWA21-10610Courtesy of VOLKSWAGEN GROUP OF AMERICA, INC.

-- Disconnect the connector -1-.

-- Remove the bolts -arrows-.

-- Loosen the clamp -2- and remove the front air duct pipe.

-- Remove the front air duct pipe downward.